1. If it is a semi-automatic cutting, then the guide rail should be placed on the plane of the titanium plate, and then put the cutter on the guide rail, noting that the order can not be reversed.

2. Cutting parameters should be appropriate, and should be reasonably determined according to the thickness of the titanium plate, so as to obtain a good cutting effect.

3. Cut the nozzle gas to check whether it is smooth, if there is a blockage should be dredged in time.

4. Before cutting, the surface should be cleaned up, and leave a certain space, which can be conducive to the blowing out of the slag.

5. The distance between the mouth cut and the surface of the titanium plate should be appropriate, either too close or too far away.

6. The preheating of the titanium rod should be sufficient, so as not to affect the cutting process.

7. If you cut workpieces of different sizes, cut small pieces first and then large pieces.